Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How can I access COM1 through a Dos box running with Windows Me? I need to be in Windows at the same time so I can't just boot into Dos. I've changed the registry EnablePowerManagement setting to 0 but it still remains invisible.
2 replies
by alpha-male
Can you give us a little more information about what you're trying to do on COM1? What device are you trying to access? Have you loaded it in Config.sys/Autoexec.bat? If you give us a better idea of what you're trying to accomplish, I'll try to helpfurther...
by d.a.miller
I use a microprocessor emulator which can only run in Dos and my SDE can only run in Windows. I swap between Dos and Windows to view the emulator window (small "w") and back to Windows (big "w") to amend program etc. I know it can be done because until my last crash when I had to re-install WinMe it worked perfectly. But I can't remember what I did. I know I altered the registry to change EnablePowerManagement to zero but that's not enough. Thanks for help.
Dave M
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies