Discussion Locked

Compaq Armada 1700 - CMOS/Diags Question

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to access CMOS on a Compaq Armada 1700 laptop. I've read that you need to press F2 during POST to do this, however so far this has not worked. There are no prompts during post, nor is there a "blinking cursor" which is where most instructions say I should press F2. All I get is a Compaq splash screen which clears and immediately displays the windows start screens (as usual). I've tried flashing the bios to the most recent version, which has also been uneffective. Could you please enlighten me?

5 replies

by d_v ant

Compaq uses the F10 key to enter CMOS. Press this while the Compaq splash screen is showing and it should take you right in.

by megashub

Tried that both from a cold reboot and a warm one. Both times had the same result - nothing. Boots clean into the OS. I've tried repeatedly tapping the key during the splash key, as well as just tapping it once. No effect.

by cdrummond

With the Arm 1700 the f10 will go into the diagnostic partition if it was installed before the OS. If not you will have to download it from the compaq website. You won't be able to install the diag part with the OS already installed but should be able to access the settings etc with the set of floppies.

This discussion is closed to new replies.