Discussion Locked

Compaq Proliant DL380 G2 wont boot O.S.

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Interesting problem. The server hangs when trying to boot from the C: drive. No error message, is just sits there, but I can boot the server from a floppy, and the server functions normally. The server completes POST without any errors, sees the RAID controller, drives and array. I've upgraded the system BIOS and Firware on the internal RAID controller, was not required to upgrade the firmware on the drives. Any help would be well appreciated.

6 replies

by the world is an illusion

I'm not sure i entirley understand you problem... where does the c: drive hang up? With the windows boot splash screen... the monitor just stays blank... what exactly is the problem?

by tigre_269

Nick, the server hangs when trying to boot from the C: drive. The message is, "attempting to boot from c:" It never gets to the O.S.

by techkid

sounds like NTLoader is corrupt or missing. NTLoader provides the boot menu you see with NT 4 and also with 2000. Though the menu is hidden in 2000

search KB's for proper procedure to replace NTLoader

by djuan.carter

It sounds like a boot loader issue. If at all possible boot to floppy backup the drives and reinstall your OS. Make sure when you reinstall that you use the updated raid drivers.

by kmcniff

I would like you to answer a couple of questions:
1. Has this server ever booted this OS before?
2. What version of Smart Start are you using?
3. Are you doing an assisted or manual install?

I have seen this problem with the G2 and W2K before. If this is an initial install, you are better off configuring the system and the RAID, make the support diskettes, then do a clean install booting either from the CD or make the 4 floppies and boot from them.

If this was a working system and this is a recent failure, then the boot from the CD and do a manual repair just for the boot.

by dn

I had the same problem..
The problem was that i had Quick Formatted the raid
I started over with a manual installation and reformattet the raid and it all worked...

This discussion is closed to new replies.