Discussion Locked

Compatibility Problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How can I get my HP ScanJet 4100C to work with Windows 2000? HP recommended and sold me a CD-ROM to solve this problem, but it did NOT work.

5 replies

by thechas

I assume that you are connecting the scanner to your USB port.

Do you know that your USB ports function properly?

Have you used any other USB devices?

If the parallel port, make sure in BIOS settings that the port is set to EPP/ECP mode.
Also, if you have a printer connected to the scanner, make sure that the printer is on.

Next, please be more specific as to the exact problem that you are having installing the scanner / software.

Chas

by csmith

I disagree with Ans. # 1
You may have to set the parallel port to SPP in the BIOS and in Windows, to make sure DMA1 and DMA3 are not used, when you try and get the scanner to work, using USB.
A general rule, when you hook scanners to the parallel port, try EPP first with IRQ 7 and 0378 I/O.
A lot of software likes that setup , because it is very standard.
That was just for your general knowledge.
Regards, Chris

This discussion is closed to new replies.