Discussion Locked

Computer speed up

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I speed up my computer without adding any hardware?

5 replies

by james r linn

Eliminate what you don't need. Get rid of unnecessary utilities which run at startup(except virus protection - everyone needs that).

Defragment your hard drive on a regular basis. If its too bad, backup your data, format your drive and reinstall your OS and apps, then restore your data.

Reboot your PC. Win 9X is not known for managing memory well - when an apps uses memory and you close it down, it doesn't always release the memory to the system. The only way to resolve it is to reboot. Win NT is somewhat better - it release memory properly most of the time.

I know you said no hardware, but RAM is pretty cheap these days, if you don't have enough, get enough - that makes a big difference. If you are running Win 9X with any less than 64 MB, buy RAM. If you are running NT/2000 with anything less than 128, buy more RAM.

James

by cgi¤001

step 1: close ALL running applications
step 2: clean up (delete) all temporary files (c:\windows\temp or c:\temp)
step 3: reboot
step 4: run defrag
step 5: reboot
step 6: even you said without buying more HW... buy more RAM
Perform step 1 till5 on a regular base (weekly), perform step 6 once. It pays off...

by admin

Make sure you have enough of a virtual memory swap file. I set my min and max size the same so it's not constantly re-sizing. Technically, you can also move it to the fastest part of the disk, but the real key is just to make sure you always have enough disk space for it.

Actually, there are other tricks... run DMA if you have it etc. It's hard to beat hardware though.

The other obvious thing if you have an old celeron or something is to raise the clock speed until you're at the maximum speed with a stability you can live with. Of course, this will probably lower the lifespan, but with proper cooling it can still last longer than you would want to use the chip anyway.

by ashutosh.lawate

Well i do think you should do carry out following things.
First of all remove all unwanted lines from autoexec.bat file, also do remove unwanted programs from loading in startup (Run Msconfig and remove them), also do scandisk the hdd, remove chk files, tmp files and then do defragment the hard disk.

ashutosh

by timmitchell

Don't forget to check your registry for programs that will start automatically. Of course, if you're not terribly comfortable with editing your registry, STOP READING NOW. The tip below assumes that you have some experience editing the registry, and that you are comfortable doing so.

Open the registry editor. Go to HKEY_LOCAL_MACHINE\Software\Microsoft\Windows\CurrentVersion\Run (Also RunServices, RunOnce, RunServicesOnce, etc.) Look for any apps or services that you don't need. And unless you absolutely have to have it, take the task manager out of there.... it's a resource hog.

If running NT or 2000, check the same key above, plus any key under the Go to HKEY_LOCAL_MACHINE\Software\Microsoft\WindowsNT\CurrentVersion\Run (and again, \RunOnce, RunServices, etc.).

Finally, and I know this is repeating suggestions from previous posts, get some more RAM. It's like money.... you can never have too much. I checked on www.tcwo.com earlier today, and 128mb of PC133 was $15 plus shipping. Worth the upgrade at twice the price.

Good luck

This discussion is closed to new replies.