Question Locked

Computer won't power up with hard drive connected

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Title says it all really. Tried to install a new ninja CPU heatsink yesterday but upon trying to start up my computer afterwards I get a brief flick of power (I can see the CPU fan flick briefly) and then nothing.

Disconnecting the hard drive results in a normal boot. It recognises the CPU, memory, floppy and DVD drive but then obviously gets no further without a bootable medium.

The obvious thing that springs to mind is that I damaged the hard drive during the install of the new heatsink but was wondering if anyone could shed any other light on this. The other thing I thought could be a possibility is a problem with the power unit (not supplying enough) but not really sure.

I should also add that I have also removed the new heatsink+fan and reinstalled the old one and I'm getting the same problem.

Any help would be greatly appreciated

11 replies

by rkuhn040172

If it's an older ATA drive, it's pretty easy to accidentally reconnect the data cable upside down and you'll see something similar to what is happening.

by davedxb

baught an external toshiba 120 gb hard drive connecting it by usb...cause computer not to start up...just pauses until i remove usb then pc boots fine.

by rkuhn040172

Go into the BIOS and disallow booting from USB devices.

It should work fine if the primary boot drive is a higher priority but I've seen this with USB thumbdrives as well.

Turning off USB boot devices seems to do the trick.

by tycho_brahe

Thanks for the reply.

The drive is a Maxtor DiamondMax 21, and as far as I can tell the data cable will only go in one way.

by mjd420nova

Check that data cable, be sure the ribbon cable is plugged in correctly. The ribbon cable should have a stripe in one edge, that denotes the NUMBER ONE PIN and should be oriented closest to the power connection. You could also remove the drive and while it is plugged in, rotate the drive physically while applying power. Sometimes the platter gets frozen and will fault the power supply. If it starts then, backup immediately and replace it.

by tycho_brahe

Thanks for the help.

The data cable is a serial ATA cable, are you referring to an IDE cable when you say it will have a stripe as I see no stripe on mine.

I will try the other suggestion and see what happens.

Thanks again.

by rkuhn040172

Plugging the SATA cable into a different connector on the motherboard?

Perhaps that input/output is bad.

by davedxb

*SLAPS himself in the head*

Why didnt i think of that...

Good point...thanks!

by tycho_brahe

Thanks again for the replies.

I have already tried the other connectors but no luck. I'm starting to think I definitely must have messed up the hard drive during the install of the new heatsink.

Have ordered a new hard drive so will be able to test that theory soon. Until then any more suggestions will be welcome.

Thanks.

by tycho_brahe

Took delivery of new hard drive this morning and plugged it in and the system boots just fine.

Luckily this was a fairly new system so not a lot of data lost from old drive but I'll definitely be backing up this new one.

Thanks to everyone who posted suggestions and hints. It was very much appreciated.

This discussion is closed to new replies.