Discussion Locked

computer wont recognise scanner

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
have a computer running win2000 and have a microtek scanner E6XL and scanning software. The problem is tha tevery time i load the software it scans one page freezes and then I have to reboot the coputer and then it does not recognise the scanner the scanner uses an adaptec scsi card and i also tried to delete the scsi card from the hardware profiles and it reloaded and then the same thing happened all over again. So what can i do short of buying a new scanner? My computer also uses a LAN if that helps any. Thanks in advance!

2 replies

by thechas

Start with the SCSI card.

What IRQ is the card set for and using?

Microtek states that the SCSI card MUST be set to an IRQ between 9 and 12.

http://support.microtek.com/~admin/pce6guide.html

You may need to move other plug-in cards to different slots.

How about the SCSI terminator?

All SCSI cables MUST have a terminator.

I wonder if there is a conflict between your network card, and the SCSI card?

Also, when you need to set an IRQ for a card, I like to make sure that it is installed in the slot that the motherboard assigns that IRQ by default.

You will need to look closely at the motherboard manual to find out what slot is assigned which IRQ by the BIOS.

Chas

by djent

Which model Adaptec card, what setup parameters, when it hangs do you have SCSI drive activity LED on solid? Is the card an OEM version supplied with the scanner? If so you might try a commercial version of later vintage.

This discussion is closed to new replies.