Discussion Locked

Conductor cable error with Maxtor HD

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a custom made PC that i made myself. It has a Soltek motherboard and a Maxtor white label hard drive. When booting my system i recieve an error message: "Primary IDE channel no 80 conductor cable installed". When i swapped in several different (older) Western Digital drives i no longer recieved the error, i even tried swapping cables on those good drives as well as the maxtor to see if the cabling is at fault. I went so far as to get a replacement drive from the manufacturer (the previous one was losing data) but i still get the error. I've not yet been able to find a solution and thought i could see what information i could turn up here. What is causing this problem? I have a hunch that my mainboard controller is bad.
Thanks
Matt

9 replies

by opatzg9

Solve the problem and get the speed from your drive with a pci ide card. Can be found under $30. Look under closed logs for pci ide. Otherwise I thought I read that the cable is different on the larger drives and older motherboards may not support them. Good Luck.

by thechas

If the motherboard is ATA 66, 100, or 133 compatible, and the Maxtor drive is also an ATA66 or faster drive, you need an 80 conductor IDE cable to support the fast transfer rate.

Further, there is a correct orientation for the 80 conductor IDE cables.

Some motherboards can detect when the correct end is connected to the motherboard.

So, you either need to swap the ends of the IDE cable, or buy an 80 conductor IDE cable.

Chas

by yelhsa3840

the cable you need has a blue connector for where it plugs into mainboard and the wires will be VERY small compared to a normal ide cable get one, and keep it as short as you really can this is for performance longer cable takes longer for data transferr

by cglrcng9

Just as an addendum to the above...An 80 conductor cable for IDE HD usage must be no longer than 18" in length (imperative), Blue connector is for Mobo IDE channel connection, Gray is for Slave Drive connection, Black is for Master Drive connection- pin #1 on each should have the red line (along the edge of the cable)matchup. The "older" drives do not need the 80 conductor cable and will operate on a 40 conductor cable w/out the additional ground wire for each pin on the drive.

This discussion is closed to new replies.