I checked on a few things.
From what I reviewed, you need to have your boot files and perhaps even your Operating System on a separate disk from your RAID array.
RAID arrays are best used for the storage of critical data files. Having your OS and application programs on the RAID array can actually reduce system performance.
From the RAID section of the Mass Storage Tutorial at www.tomshardware.com, they recommended installing Windows on your boot drive, then setting up the RAID array on additional drives on the RAID controller.
With the SATA RAID controller on your motherboard, the RAID array is a combination of hardware and software.
You need to load a driver before the RAID volume can be accessed.
Looking at the Asus manual, you can set up a RAID array as your only volume.
There are 2 sets of instructions for RAID setup.
One for a Promise Fast-Track RAID controller.
One for an Intel SATA RAID controller.
Did you check the Asus CD for the manuals for the RAID controllers?
The information there may be helpful.
You have 2 sets of SATA connectors on the motherboard.
1 is for "normal" SATA drives.
The other is for a SATA RAID array.
Start by making sure that the BIOS settings are correct per the manual for the RAID controller you are using.
Enter / load the RAID setup utility.
Configure your RAID array.
Follow the specific instructions for the RAID controller to install XP.
You will likely need to load the driver for your RAID controller during the XP setup process.
You can find detailed guides for Promise Controllers at www.promise.com
A data sheet for the Intel MCH controller is at:
http://www.intel.com/design/chipsets/datashts/252516.htm
Remove any spaces from the pasted links.
Chas