Discussion Locked

Configuring BIOS for LPT1 settings

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a problem with an Epson DFX 8500 printer which prints slowly. I sent a mail to Epson Tech Support on it and i got the following reply

"Please configure the Bios "LPT1-Port".
SPP/normal/standard = normal SPEED
ECP/EPP = High Speed."
How do I configure this settins thru my BIOS

5 replies

by bfilmfan

You would press the F1, F10 or Del key during the first part of the boot sequence while powering up.

Then you would set the port as the support rep advised. Be aware that you if you incorrectly adjust BIOS settings, you could cause your system to not boot.

Based on your question, I would advise that you ask one of your computer savvy friends to do this for you, rather than risk incorrectly configuring the system.

by emekusman

I have gone thru the BIOS settings just after startup and I see the port settings but i don't see any where i can set ECP/EPP = High Speed."

by dustyd

You may also need to press F2, depending on your motherboard. BIOS is pretty easy to navigate. Look for Ports, you should be able to find a place to enable ECP/EPP, or bi-directional. Follow your motherboard instructions on-screen for saving and exiting.

You can also enable bi-directional in printer properties, under Ports.

by dmiles

Return to the Bios setup,select the speed of the LPT1,go to SPP and highlight is then right-click on spped to get drop menu,you should be able to select the correct speed.

This discussion is closed to new replies.