Question Locked

configuring Sata hard drive on newly built system

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Under section (2) of my MB manual on Configuring SATA Hard drives,
Step 2 is "Configuring SATA controller mode and boot sequence in BIOS
setup"..

The manual states to go to integrated peripherals > Serial-ATA RAID
Config and then to ensure that NV SATA RAID function is enabled.

It states to skip the next section (3) entitled "Configuring RAID set
in RAID BIOS", if not creating raid array.

So do I still set NV SATA RAID function to "enabled" in step 2 if I'm
not creating RAID array ?

I will only have one Serial ATA hard drive initially and do not yet
want to set up raid function.

2 replies

by hal 9000

For any SATA drive to work. You are only told to skip the next section if you are not configuring a Firmware RAID Array which you say that you are not attempting to do so naturally you don't need to establish a RAID Array or Function Level RAID.

Col

This discussion is closed to new replies.