Discussion Locked

Connecting to ISP with 56K modem

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Gateway Solo 1200 laptop with a 56K modem (factory installed). I also have a IBM compatible desktop with a 56K modem. My question is, when I connect to my ISP with the desktop I connect at between 43 and 48,000bps. When I dial up with the laptop using the same phone line and dial-up number, I connect at only 19 to 24,000bps. Why wouldn't the laptop connect at the higher rate?

11 replies

by ann777

I recommend that you check the laptop settings for the modem. See if the IRQ is being shared with any other hardware on the laptop. And isolate the modem to it's own irq.

If the above does not improve modem communications, you may need to download updated drivers from the manufacturer of the modem.

It sounds as if the line is okay, so i'd suggest looking at the modem/computer. The modem may be bad or it could be set improperly or it could be sharing resources. Any of these couldcause a slowdown.

by otl

Are you using the same jack and telephone cable? If not try using the one connected to the back of the desktop. Could be a bad jack or cable.

If you are using the above, answer #1 is one possibility. Have you tried the laptop from another location? Is the connection speed throttled back in properties. Is the modem throttled back in its properties. Are both modems the same type (WIN, V.90)? Have you checked for the latest drivers?

Have also found that if an ISP has a bad modem it will usually be the first one in the pool! When someone gets a bad connection and drops this will be the next one to recieve the inbound call.

by grump

Check the modem in the laptop. If it is Flex or X2 technology, you might find that you ISP does not support either of these and you will be connecting at a much lower speed.. Today's standard is V90. Also the modem is generating noise and at the lower speed the noise is somewhat supressed and the handshake is estabilished between the laptop and the ISP modem. If the modem is PCMCIA type you can remove it. If it is built into the laptop simply install a PCMCIA modem and set it up..

by mahdeekus

Apologies if you have tried this already:

From the control panel, view the properties of the modem on the laptop. You could try to set your maximum port speed to the maximum allowable (normally 115200).

by gregz

Have you re-flashed the modem on the laptop to be 56k?? Older modems that where on the shelfs in the late 90's, stated they where 56k capable, but where really 33.6k and max speed on the older modems would only get to the upwards of 19.2 to 24.4kps.. Any good 56k modem should get the speed of aprox. 43.3 to 48.8kps which is max speed.. Or to make simple, just network and setup for Cable or Dsl. Why stay with old school tech???

This discussion is closed to new replies.