Discussion Locked

Connecting two floppies

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm installing an old internal 5.25" floppy so I can read/copy some archived disks. What's the best way to connect it when I already have a 3.5" floppy connected to my motherboard?

5 replies

by grump

First let me say ( You'r joking? )

What you need is a dual floppy cable and one that has a card/edge connector on it.

Connect the 5.25" FDD to the cable and make sure that the PIN 1 the strip on the cable will indicate that as pin1.

You will have to set up CMOS correctly to identify the type of 5.25 drive .. Hopefully you have a 1.2mb drive!

Examine the card edge of the 5.25 closly to locate the PIN 1 orentation.

Good Luck!
Most important question I have is
Does the OLD 5.25 drive work?

by paul d. masley

Answer 1 is correct but he left out that the floppy cable will come with a twist for the last connector. I placed this comment because I have has service calls, where a user has used a panasonic cdrom ribbon cable, inserted an adapter plug in the second slot and could not figure out why both A: and B: drives tried to work at the same time with no results happening at either. This will connect to your a: drive. Go below the twist and connect the card connector to the 5.25. This will be your B: drive. Make sure that you set the B: drive up in your BIOS. Start your system and go at it.

Paul.

This discussion is closed to new replies.