Discussion Locked

Copying A Harddrive

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I copy the contents of my old harddrive to my new harddrive?

12 replies

by gbworld

The easiest method is to put the old harddrive into your computer by using an open IDE connector. If you have one, you might decide to continue to use the hard drive rather than dump it. If you do not have an open slot, take a connector off another device and load the drive.

With modern systems, the drive may be located automagically, but you may need to go into BIOS and set the BIOS to detect it. It is rare that you actually have to set the type of drive these days.

If the drive is external, you should be able to hook it up and transfer. I doubt this is the case.

Gregory A. Beamer
MCP: +I, SE, SD, DBA

by mm212

Install your new hard drive as a slave to your current disk or as a master on your secondary drive controller. Set it up in your system bios (automagically if possible).

Then you can copy your contents in a couple of ways:

1. Use a disk imaging package such as Ghost or Drive Image. These are commercial pieces of software designed for just such tasks. You will not need to partition or format your drive if you use one of these.

2. Boot to a floppy disk and use the following dos command (that you've copied from your c:\windows\command folder to your floppy drive):
xcopy c:\*.* /s /e /v d:
The c: and d: are the drive letters of the source and the target partitions respectively. This will copy all files and folders keeping all files within their respective folders. Your new drive must be partitioned and formatted before attempting this command.

Of the two methods, the commercial software is the most reliable way to go and the way I'd recommend.

When finished, remove your old drive and install your new drive as the primary master. xcopy alone will not make the new disk bootable. You will need to also copy sys.com from your command folder and sys c:.

by churdoo

Is there a Win9X install on the old hard drive that you're trying to transfer also? In other words, are you trying to transfer a working system in its entirety from your old hard drive to your new one? The above methods will transfer the contents,but will not transfer a windows 9x install.
There is a technique for transferring a Win9x OS, but it's kindof involved so I won't go into it unless I know it's what you want (in the interest of my own fingers). Just post a reply or contact me if you want the technique and I'll type it up.
--Charlie

by churdoo

Also, I think it's important to note, that the xcopy method above will copy all of the files in the 8.3 filename format, but long filename information will not be transferred.
--Charlie

by russ werner

By using Norton Ghost program, you can copy everything from one hard drive to the other with out worrying about formatting, or partitioning. Go to www.symantec.com and read up on Norton Ghost.

by thehuman

If it's a brand new drive (or not), I'd recommend using the manufacturer's (free) install program. Maxtor's MaxBlast is my favorite. It gives you the option to copy your old drive to your new one, pretty quickly too.
If it's a new drive, there should be a diskette in the box, if not, you should be able to DL it from the manufacturer's website.

This discussion is closed to new replies.