Hardware

Ask something
Discussion Locked

Copying network files

0 helpful
3 replies

by jpruitt

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
What is the correct switch to use when PERMANENTLY COPYING FILES FROM A NETWORK FOLDER. I

3 replies

by cartes

What do you mean by permanent?

I copy a lot of files, basically synchronizing users' mydox in Win98 clients, and I usually just use 'xcopy /d'

--- Hassaan
-419hrs on 16/Nov/2002 (+6 GMT)

by jpruitt

Oops, sorry for the delay. Perhaps I didn't make myself clear. I was looking for the switch that you use to permanently copy setup files/folders. The /rx[:folder] switch copies folders but the folders are deleted after setup. The /r[:folder] switch INSTALLS the folders at setup...these folders remain after setup finishes (This is the one I was looking for). However, I am going to accept your answer and give you the points because you did answer the question the way it was worded the fist time.

Thanks So Much
Jpruitt

This discussion is closed to new replies.