9 replies
by dmiles
The problem is that the fan is on its last leg,there are times when cleaning may not be enough,the fan is bad.
Before you spend to much time trying to figure out what is wrong go get another an before you cause more problems with the CPU which ismore costly than a fan.
by bathprince
by thechas
Enter BIOS settings, or run a hardware monitor program, and verify that the fan speed is correct.
In BIOS settings, you should find the fan monitor under either power management, or hardware monitor.
If the fan is spinning at less than 4000 RPM, I would spend the $5 - $10, and install a new fan/heatsink
If the fan speed is erratic, I would do the same.
If the fan speed is okay, and you wish to disable the warning (not recommended) you should be able to cursor down to the fan in BIOSsettings and hit the space bar, or the page up key to disable fan speed monitoring.
I have seen a couple of motherboards that have on-going problems with fan speed monitoring when re-booting, or re-sumeing from standby.
If this is part of your problem, then disableing the warning may be okay.
Chas
by bathprince
Hi to test if it is the fan that is at fault write down the speed stated in the bios, then remove fan/heatsink spray some WD40 in the fan near to bearings spinning by hand as you do so, replace fan/heatsink repeat speed measurement if it is a lot higher then fan is duff.
Rich
by bathprince
by franjent79
by bathprince
by bathprince
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending