Discussion Locked

Cross-over Cable & Straight Cable

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Whatz the difference between Cross-over cable & Straight cable ??

why do need cross cable when connect two pcs directly ??

what happens if we connect straight cable directly to two computers ?

8 replies

by mike j

difference between Cross-over and Stright Cable is the transmit and receive wires are crossed in the cross-over cable.

A Cross-over is used between two PC because it links transmit on pc1 to the recieve on pc2 and visa-versa.

Nothing much.

by jimbb

It's a bit more complicated than this, but just imagine only two pins are used in your ethernet connector: in and out. If you send, it comes from the out-pin, and should go to the in-pin of the other PC. So you need a wire going from out to in, and one from in to out. This is why you need a cross cable to connect two PCs directly.

If you are using a hub or so, that device will do the crossing for you, that's why you need a straight cable for that.

And what happens if you use the wrong cable? Nothing at all.

Jim

by jimbb

Seems like my cache had hidden Mike J's answer before I could send mine...

by estebandelatorre

1.- They have some wires "cross" at the connector. The straight cable is mapped pin to pin on both edges.

2.- Data Terminal Equipment versus Data Comunication Equipment connection. This is an IEE "standart" that watches on how two type of equipment (in this case DTE (Pc) DCE (modem, hub, switch, etc) should be connected.
3.- They won't work like a peer to peer network. No risk of damage, but it won't work

This discussion is closed to new replies.