Discussion Locked

CRT Monitor Image folds in on itself

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have just installed a new HP dx2000 at a remote site and connected it to the existing CRT 17" Monitor. The monitor had been working fine with the previous PC - an HP Brio running XP. Now about five minutes after the PC is switched on the screen image begins to fold back behind itself at the top and squashes up at the bottom until after half an hour the Taskbar has disappeared into a hairline and the top half of the screen has completely folded back. The menus in whatever software is being used are upside down and reversed and if moved up the screen the mouse pointer will roll back down the top half. I hope this all makes sense as it's driving the users mad. They have to shutdown for half an hour to allow the monitor to "reset". I have tried degaussing and changing the drivers, resolution, refresh frequency all to no avail. Any advice welcome.

3 replies

by black panther

Does another different monitor work ok on the new HP dx2000 ie not the CRT??

Check the Video Card is seated properly.

Have you got the lastest XP drivers for that monitor??

Have you turned off the Power Saving Features in XP in case that is upsetting the monitor?

Re-check that the CRT monitor will work on the old PC again?

by absolutely

Since the problem arises gradually, it most likely has to do with electromagnetic interference that did not happen before because of the location of the monitor relative to some other device that's emitting EM radiation.

Your monitor, if it's any good, has a DeGauss option, either within the picture quality menu, or on its own button along the bottom of the monitor, usually to the left of the power button. Hit the DeGauss button, a capacitor discharges, and your problem is solved until it happens again. DeGauss again...also, you could move your fan away from your monitor, those are notoriously the worst for messing with CRT's.

by wlbowers

Sounds like a heat related problem with the monitor.

Put it on a different computer to verify, or put a different monitor on the dx2000.

Ya gotta start somewhere.

Lee

This discussion is closed to new replies.