8 replies
by ann777
Yes, there's an article "200 ways to revive..."... it's in the Downloads section... then just search for 200 ways
by amfdale
by dmiles
See the following threads
https://www.techrepublic.com/article.jhtml?id=r00320000511jed01.htm&src=search
by amfdale
by cglrcng9
Is the drive spinning up @ all? Is it clicking? Are you sure the drive parameters that are set in the CMOS settings match the parameters of the drive? (Usually printed on the drive label). Are all drive jumpers set correctly?
You may wish to try this even though it sounds far out, I and others have had success w/ the method. 1. Remove that dead drive that refuses to spin up from the case and allow it to cool to room temp, insert it in a zip lock type bag to keep moisture from invading the drive during the freezing process, stick it in the freezer for a few hours or overnight, remove it & install in a fairly cool computer, boot it up, and quickly transfer any info needed, repeat if necessary, but don't count on this method working for too many tries as it will usually fail on the third or fourth attempt for good.
2. Replace the control board w/ an identical board from a spare same model & type drive.
3. If it is clicking repeatedly and the parameters are properly set, then youprobably have a head problem and none of the above will help you. That drive is as dead as can be!
by cglrcng9
Also a search for "Dead Drives" @ Langa.com will yeild a few more dead drive fixes.
Good Luck.
PS..I always have liked the one about putting a FDD and many types of system boards thru the home type dishwasher then the real low temp oven trick....It actually worked on some old dead FDD's I had hanging around, didn't try the oven though, the 1 day in the AZ sunshine & low/low humidity during the summer satisfied my dry time. I couldn't believe that they (all old ancient drives & boards), worked again after a simple wash & dry! Go figure!!!
by amfdale
by amfdale
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending