Discussion Locked

dead hard drive

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a fujitsu 30gb hard drive running windows xp professional, while working on it, a blue screen came up with error Kernel stack inpage error, please restart. I restarted and now cannot get the computer to recognise the drive in the bios, i have tried putting in the specs of the drive manually, but no luck, any suggestions?

6 replies

by joematus

First check the cables for the drive to see if anything is loose. Most likely he cables are OK. If the BIOS can't see the HD but it can see your other devices, then I'm afraid your drive is dead. This does happen on occasion. The bad news is that your data is lost if it wasn't saved off somewhere. The good news is that newer and bigger drives are pretty cheap such as 80 gigs for 80 bucks. Since the drive is 30 gigs it most likely is too old to be still on the warranty.

by jac66

I work in a secondary school, unfortunatly fujitsu drives are notorious for dying without warning especially if they are about 2 yrs old. I have a tray with 17 HD in that have all failed aroung the same age, all fujitzu and all the same model. After contacting Fujitzu i learned that there was problem with certain model HD's.
It may start normally again after being left switched off for a day or two but that wont last long , usually about 20 mins and it dies again. For arounf ?40 you can pick up a decent HD at any computer fare, much less worry.

by rrankk

If possible, set the jumper settings on the back of the drive to slave and add this drive into a different working computer. Possibly may be able to save some information unless the working computer does not see this drive either.

Also, in amongst all the information on the drive, there will be the model number and date of manufacture.

This is the link to see if the drive is still covered under the manufacturer's warrenty:

http://www.fcpa.fujitsu.com/warranties/warranty-information/

Hope this helps...

This discussion is closed to new replies.