5 replies
Try this URL from Cisco (no spaces):
http://www.cisco.com/warp/public/779/smbiz/service/knowledge/general/recovery2.htm
Hope that helps -
by mja
by rgrowcock
This is a little involved, but I'll give you as detailed answer as possible. I will assume that you are connecting to the router through a HyperTerminal with a Console cable.
1. Open a HyperTerminal
2. Boot or ReBoot the router
3. While therouter is booting, press the Ctrl + Break keys. The router will give a message along the lines of "boot" aborted due to user interrupt."
4. Type "o" lower case O
5. Type "o/r 0x2142" This resets the registry setting.
6. Type "I" for initialize the router
7. Now when the router reboots, it will ask you if you want to enter "setup" and just follow the steps to create a new configuration and make sure to copy that into the running configuration. You can use "copy run start" to do that.
8. The last thing to do is to reset the registry back to the original setting which should be 0x2102. To do that go into "enable mode", type "conf t" and then type "conf-reg 0x2102.
9. Type "reload" and reboot the router.
This is all there is to it. It sounds like a lot, but it doesn't take long to do it. The hardest part is making sure you get the break to happen when you first boot the router. You may have to reboot the router several times until you get the sequence right. Hope this helps. Roger
by mja
by mja
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending