Discussion Locked

Dell L800r - Com Port Problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I suspect that com ports must have gone changes that I am unaware of. I am currently attempting to connect a bar-code scanner to com 1 of the above computer. I have tried from DOS and a DOS window beneath Windows 98. Only one time has the device ever been recognized and only when the machine was booted to DOS. All of my other experiments and tests to determine the problem have led nowhere. I have tried this on two different machines that are configured the same so I don't believe it's a hardware failure. If anyone has beat this problem, I would appreciate your input. Thanks!

5 replies

by dcosgrove

Depending on where that bar code reader came from it could have many types of 9 pin configs. May are designed to run off a hub as stand alone wedge readers and have a pin out specific to the network. If you give a little more info as to what type of reader it is, I may have lists for it. I work with a lot of intermec and eltron equipment.

by rawright

You're not getting much reponse on this, so I'll throw in an idea to try.

We use a lot of serial devices at work, mostly dumb terminals on serial hubs, but some PCs as well. The system uses a three-wire connection, but some (not all) PCs will not respond. You don't mention what kind of scanner you have, but it may not implement any hardware handshaking, and your PCs may require it. To fool our non-responsive PCs I have to loop back the DTR signal back to the DSR and CTS inputs at the PC port. You might find that your systems will respond to this. For a DB9 port, connect pins 4,6 & 8; for a DB25 use pins 20, 5 & 6. I hope this is helpful...

This discussion is closed to new replies.