8 replies
by danpiers
I'm not a Dell expert for sure, but I may have a few ideas for you.
First, Are the processors the same brand, i.e., both Pentium III or Celeron. If not, the systems can act very differently due to microcode variations. Especially if one is an AMDand one is an Intel.
Second, the IDE channel greatly affects boot speed. Are both using UDMA for their harddisks? Is one drive 7200rpm and one 5400rpm? Are the transfer rates significantly different? How about disk fragmentation? I recommend performing a thorough SCANDISK and DEFRAG on each system. Sometimes, a bd FAT or Boot Sector can slow down boot up.
Third, do they both have adequate free space on the harddisks? Is the disk cache on both set to "controlled by Windows?"
Fourth, isthere a virus checker running on both? Is it set to search the same amount of files on each? It is possible that the virus checker has a lot more checking to do on the 20GB harddisk than it has to do on the 10GB harddisk.
Fifth, Anything in the PCMCIA slots?
Sixth, and finally, more RAM means more time checking the RAM.
Hope this has been a little bit helpful.
Well, I always say clean out the Temp and Temporary Internet folder under C:\Windows directory. If there are thousands even hundreds of garbage files left behind, it will slow your machine down. And definitely run a defrag over night. The defrag will fill in the holes and speed up the machine.
Good luck with that.
by e_thorn72
by nick burns
by e_thorn72
by e_thorn72
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending