Dell Latitude D600
http://support.ap.dell.com/support/edocs/systems/latd600/
Viewing the System Setup Screens
Turn on (or restart) your computer.
When the DELL? logo appears, press < F2 > immediately. If you wait too long and the Windows logo appears, continue to wait until you see the Windows desktop. Then shut down your computer and try again.
--------------------------------------------------------------------------------
System Setup Screens
The system setup screens display the current setup information and settings for your computer. On each screen, the system setup options are listed at the left of the screen. To the right of each option is the setting or value for that option. You can change settings that appear as white type on the screen. Options or values that you cannot change (because they are determined by the computer) appear less bright.
The upper-right corner of the screen displays help information for the currently highlighted option; the lower-right corner displays information about the computer. System setup key functions are listed across the bottom of the screen.
The screens display such information as:
System configuration
Boot order
Boot (start-up) configuration and docking-device configuration settings
Basic device configuration settings
Battery charge status
System security and hard-drive password settings
--------------------------------------------------------------------------------
Commonly Used Options
Certain options require that you reboot the computer for new settings to take effect.
Changing the Boot Sequence
The boot sequence, or boot order, tells the computer where to look to find the software needed to start the operating system. You can control the boot sequence using the Boot Order page of the system setup program.
The Boot Order page displays a general list of the bootable devices that may be installed in your computer, including but not limited to the following:
Diskette Drive
Modular bay HDD
Internal HDD
CD/DVD/CD-RW drive
During the boot routine, the computer starts at the top of the list and scans each enabled device for the operating system start-up files. When the computer finds the files, it stops searching and starts the operating system.
To control the boot devices, select (highlight) a device by pressing the up- or down-arrow key, and then enable or disable the device or change its order in the list.
To enable or disable a device, highlight the item and press spacebar key. Enabled items appear as white and display a small triangle to their left; disabled items appear blue or dimmed without a triangle.
To reorder a device in the list, highlight the device and then press < U > or < D > (not case-sensitive) to move the highlighted device up or down.
Boot sequence changes take effect as soon as you save the changes and exit the system setup program.
Performing a One-Time Boot
You can set a one-time-only boot sequence without entering the system setup program. (You can also use this procedure to boot the Dell Diagnostics on the diagnostics utility partition on your hard drive.)
Shut down the computer.
Connect the computer to an electrical outlet.
Turn on the computer. When the DELL logo appears, press < F12 > immediately. If you wait too long and the Windows logo appears, continue to wait until you see the Windows desktop. Then shut down your computer and try again.
When the boot device list appears, highlight the device from which you want to boot and press < Enter >.
The computer boots to the selected device.
The next time you reboot the computer, the normal boot order is restored.
Edit: format