Discussion Locked

Dell Latitude XPi adding memory

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I want to add more memory to my Dell XPi. It now has only 16meg. Do i have to open the pc or can it go in one of the panels on the back of the PC.

5 replies

by thedrummer2006

Im not for sure what the specs on a Dell XPi are but memory is pretty much the same for any computer. Yes you will have to open your tower or case. The memory is mounted on your motherboard. From the way you asked the question it sounds like you've never seen a memory chip before so first you need to know what kind of memory your motherboard uses. If it is a newer computer it will be alot easier to put memory in it. On the newer computers pentium 2 and up or compatibles the memory is pretty much going to be one type. In older computers they used either PARITY or NON-PARITY and depending on the type your motherboard used depends on how many chips you had to install at a time.
Parity had to be installed in pairs.
Basically you need to pop your case open and see what kind of memory is being used like for instance Pentium 2 & early 3's used 128 pin DIMM. Then you need to make sure that you have an open slot on your motherboard.
They will be long flat modules standing up perpendicular to the motherboard, about an inch 1/2 tall and 4 or 5 inches long.
Be sure to discharge any static electricity on your hands before touching the memory. Memory chips are very succeptable to static electricity. I like to keep one hand on the metal part of my tower while handling any memory, or you can go to your local electronics or computer store and purchase a static wrist band for a couple of bucks this will take care of the problem. If you are unsure of the memory type call Dell Tech Supportand they will tell you what kind it takes.

Good Luck
Chris E.

by rwlap

This is from Dell manual for the XPi. You can also use their site to find correct memory modules and maximum your model accepts.
Note: the memory compartment cover is on the underside of laptop - you should remove all power and battery first.
1.Remove the memory compartment cover.
2. To release a memory module from its socket, gently push outward on
each of the memory module?s two metal retaining clips.
The memory module should rotate upward out of its retaining clips.
3. Lift the memory module out of its socket.
Memory modules can be installed only one way. Do not attempt to force the
memory module into the socket. Align the notch in one corner of the memory
module with the corresponding indent in the memory module socket.

Good day!

This discussion is closed to new replies.