Discussion Locked

Deskjet 1220C carriage sticks

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The carriage is sticking in the left hand postion rather than returning "home". I have cleaned the rod it slides on. I can't see anything obstructing the slide. Any ideas?

2 replies

by thechas

1. Bad drive motor or toothed belt.

2. Ink buildup blocking cartridge from moving.

3. Out of position print head covers or cleaning pad.

Chas

by wlbowers

Grab the carriage and see if it rocks on the rails. Depending on the amount of service it has seen the guides could be worn.

Make sure there is no obstructions on the left side of the carriage run. You could be getting a positioning error.

Good Luck Lee

This discussion is closed to new replies.