6 replies
by dave.osborne
What version of windows are you running? Old comptuer sounds like either win 98 or win 95 possibly? Have you tried setting the CD-ROM to something like H: or so just to see if it will keep the setting after rebooting? Are you sure the jumpers on the back of the CD-ROM are set right (master/slave) for where it is on the IDE cable? You might also want to consider replacing the battery on the MB or just FFR(fdisk/format/reload) the whole system, that should definitely get things working like you want and a fresh start is always the best. Hope this helps.
-Dave
by dave.osborne
by digital echo
by thechas
I guess that I am confused as to what the problem is.
By default, Windows assigns all Hard drives letters, then assigns the next available letter to the CD drive.
Conflicts and problems can occour if the DOS driver for the CD is installed, andsets a specific drive letter.
Unless you need DOS mode access to the CD drive, I recommend deleteing any lines that refer to the CD drive, or mscdex in the Autoexec.bat and Config.sys files
You can edit these files from the run box using the command sysedit
If the proper letter is assigned to the CD drive, and you have problems reading CDs, you most likely need to re-install the chipset drivers for the motherboard.
If this is a name brand PC, just go to the mfgs web site.
Otherwise, you need to identify the motherboard.
Go to either www.motherboards.org
or www.wimsbios.com
Both have tools to help you identify the motherboard, and links to manufactures web sites.
If the problem is anything different, reject my answer, and provide additional details.
Chas
by digital echo
by digital echo
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending