Discussion Locked

different operating systems on PC

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a desktop PC with a removable hard drive carriers, each hard drive carrier has a different operating system installed on it, on my old PC i would take out lets say the windows ME hard drive carrier and put in a windows 2000 hard drive carrierand it would boot to that sysytem, but with my new machine each time i try to install a new operating system onto a blank hard drive it fails the installation, a friend of mine suggested that the reason i cant install other operating systems onto mynew Pc is because i installed windows XP first onto my PC and XP has written to my motherboards bios, thus not letting other operating systems to coexist with it, is there any way that i can have multiple operating systems, each on its own hard drive on a pc that i have installed windows XP onto?

7 replies

by timwalsh

Windows XP does not write anything to the BIOS.

How do the installations fail? Are you getting error messages? Does the BIOS recognize the hard drives properly?

This is a case of either a hardware issue, improper installation technique, orcorrupted install/boot disks/CDs.

Or are you attempting to use the removeabe drives from your old computer? If this is the case, chances are that the old installations do not have the proper hardware drivers installed to allow your new computer to complete the boot process.

by joseph1

XP does not write to anywhere but the hard drive so if you are switching hard drives XP is not the reason.

I suspect the removable bays as being the problem. To check this try installing the other OS on a disk but using the removable bay that youused for the XP disk. If that doesn't work then try using the good bay and the good disk.

Good luck.

by thechas

I agree with the root being the old drive trays.

Not because of a driver, but because the motherboard is trying to run ATA133, and the hardware in the drive trays is not up to the speed.

You should be able to confirm this by disabling UDMA mode in BIOS settings.

Chas

by jonmustafa

All the drive trays are the same make and model and all are just over a year old, why would 2 of my drive bays and my drives with windows XP work, and the others create errors? Microsoft suggested that it could be the motherboard itself which may be coding information onto its bios.

by thechas

Re: Your questions:
All the drive trays are the same make and model and all are just over a year old, why would 2 of my drive bays and my drives with windows XP work, and the others create errors?

What is the data transfer / UDMA rating of the 3devices?
Motherboard
Drive trays
Hard drives

What I suspect, is that you are exceeding the rated transfer rate of the drive trays, and you are getting "lucky" on the ones that work.
Devices rated for UDMA/ATA 133 can work at the lower UDMA66 speed.
However, not all UDMA66 devices (even from the same mfg) will function correctly at ATA100 or ATA133 transfer speeds.

Set the motherboard BIOS to use the slowest of the 'rated' transfer speeds, and the problems should go away.

Chas

This discussion is closed to new replies.