Discussion Locked

Digital to analog

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a GSM modem with an RJ45 audio output interface, I need to convert this output and connect it to a normal PBX

3 replies

by csmith

Unfortunately there is no "normal PBX" they are proprietary. Another small error, RJ45 is the UTP network plug, (It has 8 contacts) RJ11 is the telephone plug. It has 2,4,or 6 contacts installed. I assume it was a mental slip and you meant RJ11. No problem.
To do this you will have to go to the website of the particular PBX manufacturer and get the signal pinout of the plug they are using. (If you have the technical manual, great.)
You are looking for the "tip" and "ring" (or equivalent) signals. Make up a one foot "extender" for the station, with a tap for tip & ring signals. This will require a trip to the electronic parts store. (You have to have the desk phone to generate the proprietary control signals for line selection etc. The modem can not do it.) Attach the red and green wires from the modem cable to the tip & ring tap.
Fortunately the modem can adjust if they are reversed.
Good luck, Chris

by csmith

Got you email with tech. attachment.
My apologies, I thought you had the Option GSM Ready 56K PC Card Modem.
It has the Adapter cable and the RJ-11 plug.
From the specifications it looks like you have a GSM Falcom A-1.
I am not familiar with this product.
However, some basic technical information.
Interface A is Radio Frequency, so no go.
Interface B is the standard 9 pin COM serial port. Digital so, no go.
Interface C is a headset/handset connector with push to transmit option, so no go.
Interface D is power, so no go.
The SIM interface is for a serial connection for a smart card reader, so no go.
The unfortunate news is that none of these interfaces can be adapted at a reasonable cost.
Thus, the only reasonable wayto accomplish your goal is to upgrade the modem.

Regards, Chris

by csmith

Another oops. There is a typographical error in my comment.
Interface B line should read:
Interface B is the standard 9 pin COM serial input port. Digital input, so no go.

This discussion is closed to new replies.