Discussion Locked

Disabling Power-on Password

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I disable the power-on password of a 486-based Panasonic Laptop? There are no apparent jumpers and the battery is soldered in. At present, two laptops are useless because I do not know the password.

10 replies

by mpdcsup

If you can get to the two leads on the battery, try shorting it momentarily (less than 1 second). It will drain the battery slightly, but not completely (unless it's already low).

by diamond dan

Hi,

Another idea: depending on the model, some older 486's still had a removable bios chip. You could try pulling the chip and letting it sit for a few hours to drain the capacitance and allow it to reset that way. If you can't remove the batteryfrom the chip, remove the chip from the battery!

BTW, the previous post will probably not work for two reasons:
1) shorting out the battery will not drain the onboard capacitor, which will continue to supply current to the chip
2) the brief one second shortout is not long enough to reset bios chip data.

Good Luck,
dan

by diamond dan

and one more thing why shorting out the battery is a bad idea:

you could damage the battery or cause a premature death to the battery, and since it is onboard it could be difficult to replace. Once the battery is shot you will have to renew BIOS data every time you reboot, and I don't think that's what you want to do.

Trust me, this happened to me once, and I had to reset my date, time, hard drive specs, etc. every time I rebooted the machine. BAD IDEA!

-dan

by freetech

put the regular laptop battery in and turn on machine and set for "always on" in power management (video properties).
just leave the machine on until the machine drains its batteries and the bios (should) reset itself. if the machine doesn't go into power-saving mode, this should only take a few hours. note, this is hard on the battery life and may shorten it some.

by shanghai sam

This sounds like the solution I need. I will try this option. At present the laptops are not accessible to me. Thanks. jrbralley

This discussion is closed to new replies.