Discussion Locked

Disk I/O Error Status 00000100

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Please someone shed some light on this issue. I have an older PC of a clients and have reloaded the hard drive as well as replaced with a new on and keeps coming up "boot disk failure". I am pretty sure the motherboard is either malfuctioning, however now I am receiving the error message "Failed to Arcread the boot partition to check for a signatrure. Disk I/O Error Status 00000100.".
Stats on System.
AMD processor 433
256 RAM
20 Gb (brand new Western Dig)
Ali Mother board 1500 series
Please advise.

2 replies

by djent

Try the drive in another machine, replace IDE drivers with default driver. Could be a bad IDE controller on MB, try a Seagate drive, I have found to many compatibility issues with WD drives and avoid them. I have been building white boxes for 10+ years, if you wish I will share my views on compatibility via email.

by tickleme

Have you checked to see if your BIOS can address a drive that big, and maybe update it as older systems do have limitations.

This discussion is closed to new replies.