3 replies
by hal 9000
Well the first thing to do is get the HDD checking Utility from the maker of the drive and run it. You generally do this by inserting a Boot Floppy into the Floppy drive and at the A: prompt change floppies over and run the HDD checking utility. Although depending on the maker the boot utility could be included with the disk checker.
If it passes the Disk Test then set the Jumper to CS {Cable Select} then attach i to the end of the IDE Cable and go into BIOS on the next boot up and chose either to identify the HDD or Auto Select this again depends on the maker of the M'Board and the BIOS. I'm taking it for granted that it is an IDE HDD as you have not said differently but if it is a SATA drive and you don't already have an SATA drive installed you may need to install the SATA Driver this should have come with either the system makers Recovery Disks or on a floppy from the M'Board maker.
When you come to install 2000 you need to format up the drive and allow files to be written to it and when the system reboots at which point you'll be prompted to "Press any Key to Boot From CD" don't press any key and the install should proceed. If you keep pressing a key you are taken back to the beginning of th install process all over again and you'll be in a continuous loop of Formatting and writing files to the drive.
Of course if the HDD doesn't pass the makers test you can return it Under Guarantee.
Col
by roger
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending