Discussion Locked

Driver available?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to locate a driver for an old ISA IDE Controler card for someone and I am not having much success. I have tried driverguide.com and no result, I have searched Google.com and only got a linkto some discussion forum. The computer is veryold, I think a 386 and maybe 16 MB Ram running windows 3.11 for workgroups.

I know what you are thinkign.. why bother?
Well I wouldn't, but the person who asked me to fix it does. The only numbers I can find on the card are as follows ...Zeon 2 94VO
LCS-6624G
FCC ID: JPDVA-M1083757

I cannot see any Model name anywhere on the card, I was able to download a manual for the card, but I need to know if it requires a driver too?

5 replies

by gigelul

I work long time ago with some cards like this. I can say you that you don't need a driver for HDD less than ~500Mb. You need to set properly the HDD parameters in BIOS and also check the jumpers and documentation for this card. Start with HDD only and after that connect CD-ROM if exist. For HDD bigger than ~500Mb you need a driver from HDD manufacturer and use this to boot system for partitioning and formating.

by thechas

I looked in a couple of places that I have set aside for "old" drivers.

One is www.drivermuseum.com

They do have a number of IDE drivers posted. Most are for VLB boards.

Looking at your numbers from the board;
Zeon 2 94VO: This is the ULidentity of the company that made the "raw" printed circuit board.

LCS-6624G: This is your best number, it may however be an "internal" manufacturing part number, and not the model number of the card itself.
If this board was part of the oem package for the PC, it is likely that part of the contract was to obscure the mfg ID.

I recommend searching based on the controller chip on the card.

Most of these cards used similar controler chips.

I also agree with answer 1. As I recall, you pretty much just installed the card, conected the drives, and set the drive paramaters.

You only needed drivers for special functions.

If you have the manual, and thus the jumper settings, that is pretty much all that you need.

Chas

by daz'n'ash

Thankss Chas, I appreciate the information. I did get the manual for the card, so will just have to play with the jumpers.

This discussion is closed to new replies.