Discussion Locked

DVD Drive

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I insert a CD into the DVD drive,the computer issues the following message:
OE has entered in 0028:C182FIE3 in Vxd scsi1hlp(03)+00000583.This has been extracted from 0028:C182FI68 in Vxd scsi1hlp (03)+00000508. The computer has to be restartedfor normal use. Your advise will be appreciated.

9 replies

by md_hashim

Seems like a an address conflict - have you tried re-installing the software? Whats your system configuration? Have you tried increasing the swap size on your system?

by ann777

Boot to dos mode, rename the file from SCSI1HLP.VXD to SCSI1HLP.OLD, and reboot.

Your DVD will work fine... and everything else will work normally as well. You don't need the SCSI1HLP.VXD file to run any of these.

by bdhonline

I am sorry,but I am rather a beginner with my computer,so,what must I do to boot to dos mode please ? After the corrections which you recommend will the PC continue to work in dos mode,and if so,what have I to do to get it back to normal ?Thank you. Brian Hamilton.

by freetech

do you have a scsi card? if so, reinstall it or move it to a different slot.
not really enough info to troubleshoot. microsoft error messages are ambiguous and arcane. so it doesn't tell us all we need to know.
what is your setup: processor, drives, ram, cards, etc?

by ann777

To boot to DOS mode on a win9x computer:
click on start --> shutdown --> restart in MS-DOS mode.

then type: cd\windows\system\iosubsys

on the next line type:
rename scsi1hlp.vxd scsi1hlp.old

then power off your computer and power it back on

you should be able to use your DVD cd-rom without any other changes. You do not need to re-install the drivers. And this file affects nothing on your system.

This discussion is closed to new replies.