Discussion Locked

DVD PLAYBACK

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to configure a Voodoo 2 graphics card (pci). It is connected to a standard vga card (pci) via a loop-through cable. Under Win98SE, the display adaptor is shown as standard (16colours etc). The Voodoo 2 is shown under Sound, Video and Game Contollers.

How may I change the display adaptor to accept the Voodoo?

Mobo is Microstar 5182, on board Agp 8mb Ati graphics chip. Disabled in bios, in favour of the pci graphics.

AMD K6 2 500

256 sdram pc100

30Gb hdd.

1 reply

by thechas

I assume that this is the Diamond Voodoo accelerator card.

Do you have the correct drivers installed from either the install CD, or Diamonds web site?

Since the drivers for this card are older, you may be limited to using DirectX version 7 forfull support.

If the card and drivers are properly installed, you shoud be able to select the adapter from the Advanced section of the Settings tab of display properties.

Chas

This discussion is closed to new replies.