Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Packard Bell pulsar 300 Ser no G958400319-Microsoft driver 4-23-1999-Samsung DVD_ ROM SD-606F.I only tried to play DVDs recently without success. CDs & CD-roms work fine.Zoran software. Despite re -inserting Dvd I always get the message"DVD drive empty or not ready" Tried different DVDs.Also tried with Real One playerand with PowerDVD
2 replies
by oz_media
You MAY have a bad DVD, very common these days. The lasers are much more refined than CDROM requires due to the complex DVD layering.
Clean the drive, then have the hardware checked out.
Hello,
your DVD driver is not installed properly or the connections of data cable and powersupply cable is not in propermanner
you may configured the jumper settings improperly.
connect it in good manner then try it again.
Wishing you with regards
yours,
C.V.Udayasankar ,
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies