Discussion Locked

dvd-rom read problems

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have a samsung dvd-rom sd-608, windows 98,
and i have problems reading dvd disks.
all cd's are read just fine.
sometimes a dvd can be read but it takes
the computer a long time to read the disk
(it is sometimes a matter of minutes).
When i do get the dvd to be read, i will play
a movie and then take the movie out and put it back in and the dvd is not recognized.
i have updated the latest video and sound drivers.

7 replies

by thechas

1. Does your motherboard support DMA mode for CD drives?
If not, you may never correct the problem without getting a new motherboard or IDE controller card.

2. Do you have the latest IDE Bus driver for the motherboard / chipset installed?
Thisis likely what you need to improve your DVD drive support.
If you need help identifying your motherboard, go to www.motherboards.org, or www.wimsbios.com

Chas

by js_9

I have a micron so I went to their website and
was able to find that my motherboard is:
Tazer II - Tyan S1854 Via 133A 4X with Integrated Components

I don't know if it supports DMA mode for CD drivers, but
its the same motherboard that came with the system when
I bought it and since the DVD player was included in the
original system I would guess that the motherboard
supports DMA mode.

I went to the tyan website and it pointed me to another website where I download the VIA service pack (VIA 4 in 1). I instatlled the drivers for the IDE filter, AGP, Via Inf, and IRQ. My computer still ends up taking a long time to read the DVD and it is not always successful.

by cbach1997

Check the interface on the drive and on the motherboard for that cable for broken or bent pins. Make sure the cable's in good shape, too. Certain pins are responsible for the ID of the disc, and if they aren't connected, strange things like this can happen. I would also enable Auto Disc Insert Notification in the control panel (Device manager, then the DVDROM).

Hope this helps,
cbach1997@hotmail.com

by js_9

i took a look but i could not really see too much
and i also already had auto disc enabled.
thanks for your advice

by thechas

Based on what you have done, and the symptoms, I would see if you can get the drive replaced under warrenty.

I suspect that the laser is just slightly out of alignment. Which explaines why you can read CD's but not DVD's.

Your system definetlysupports UDMA mode for all IDE devices.

Chas

This discussion is closed to new replies.