4 replies
by mtrooney Accepted solution
by dmiles Accepted solution
Have you set the jumpers on the dvd to reflect master/slave
Now put on cable that will reflect master slave,you should be able to set up the dvd drives on the sec if you want
Hope This Helps
by yanno99 Accepted solution
Put both hard drives on your primary ide channel with your boot drive as master and reset the jumpers on your second hard drive for slave. Then put your dvd's on the second ide channel with one set to master and one set to slave. I assume you know how to change the jumpers on the drives. Let me know.
Check your bios setup to make sure they are all recognized.
by mtrooney Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending