Question Locked

eide on gateway motherboard will not recognize hard drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just recently bought a surplus gateway computer from the state. The harde drive was wiped but the system is in good shape 1.9 pent 4 with 512 of rambus memory 64 meg vid card, good stuff but when I try to load the hard drive the system will not see it. I have tried different cables, different drives, I even switched the cable from the optical drive to the hard drive slot and the board then picks up the cd as a master so the eide ports work I just can't get them to see a new hard drive. Is it possable that the motherboard drivers for gateway are what is stopping me, or rather the lack of them, Is there any way to get arround it.
Please help
Dennis

3 replies

by thechas

Check the jumpers on the hard drive. Many drives need specific jumper settings to boot as a master with out a slave drive present.

Also, make sure that you have an 80 conductor cable and that it is oriented properly.

Chas

by hal 9000

Go into BIOS and make sure that the Drive is been seen there it's always possible that the HDD is dead and that is what your problem is.

Col

This discussion is closed to new replies.