Discussion Locked

Enhanced parallel port?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a pentium 233 PC and am considering buying a Mustek Plug-n-Scan 12000 III EP Flatbed Scanner. The scanner specs say it has an "enhanced parallel port". Is that different from the parallel LPT1 and 2 ports on my pc?

5 replies

by vinnyd

You need to check in the BIOS of your computer to see what the Parallel port can be set to.

When you boot the computer there should be a prompt that tells you how to get into the BIOS settings.

I have seen BIOS using the DEL key, the F1 key, CTRL ALT ESC, and some others.

Once in the BIOS find the page that has the parallel port on it.

See what options you can change it too.

There is EPP (Enhanced what you want), ECP, and normal in most computers.

by jdkline

No, LPT1 is your "enhanced parallel port" or (EPP). You just need to enable it in your BIOS setup (see answer 1). Most BIOS' default to "standard parallel port" (or SPP) when reset which is one direction (out) communication. EPP and the later Error Control Protocol (ECP) are both bi-directional standards which the your scanner requires.
The other 2 ports are serial ports. These ports won't work with your scanner.

This discussion is closed to new replies.