Discussion Locked

EPOX motherboard

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an EPOX 7KXA Slot A with 850 Slot A processor.

First MB I installed would not boot. I got a series of beeps. Was told by EPOX support that meant video error. Replaced MB. This one the PS/2 mouse port wouldn't work. Replaced this damn thing again. Now I get the same video error, and I've stumped EPOX support. Lucky me. I've tried different video cards. Tried running it out of the box. Different memory. Don't have a PCI video card to test with. Is it really the MB, or is it some component that may be conflicting. Out of the box, all I'm running is the video card, the processor, and the RAM. It did for a while go through POST. Now it won't even do that.

Help...and Thanks:)

15 replies

by barmaley

Is it possible that you got the first motherboard back?

On your place I would exchange it again.

by lhollan

no I didn't get the same one..I sent the first one back after I recieved the last ones

by shanepri

In my experience with mb, I've came across similiar situations. Most suppliers/wholesalers buy their products in bulk from manufacturers. That being the case, when 1 board goes bad, there is a good chance another one & another one will follow. The reason is usally due to a critical part of the assembly line going down or being off by a hair, during the manufacturing process. If that is the board you "must" have, take it back & wait a week. Or, try another company.

by mindcrazy

I am guessing from your post that you are using an AGP video card. If this is true, it is possible you do not have the right drivers for your chipset. Through my experience, running VIA chipset with an AGP card may cause a series of beeps on post and stop. Are you getting any video at all when you turn on the system? I would do my best to test the board with a PCI video card first before going any further. Good Luck, I hope you find a solution to your problem.

by lhollan

No there is no video. I'm thinking I must have the right drivers, as the card worked perfectly on the second board.

by shanepri

When you push the vid card in the agp slot you should hear 2 clicks. If three agp cards all did the same thing in the board, it could be that the card is not seated properly. Agp cards are notorious for that.

by allswell

Okay,
I just upgraded a machine for a guy with one of these. On first startup I got no video!!! Tore the thing apart rebuilt thinking I did something wrong. Still No VIDEO!! Then I checked the MB jumpers and dips, guess what, You can't run the Athlon with the fsb set at 133mhz try turning it down two 100mhz see if it works. Also as silly as it sounds check to see if the processor is in the slot all the way.

Hope this helps!!!

This discussion is closed to new replies.