Discussion Locked

Epson 740, 850NE: White Banding in Print

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

As a repair tech for about 25 school districts, I've seen tons of Epson Color stylus printers come through here, the most common problem seems to be clogged printheads causing white banding in either the color or black print. Recently One of our districts sent 4 Stylus Color 850Ne and 2 stylus color 740 printers for repair, complaining of white banding in the print. Typically a new cartridge and 5-10 cleaning cycles clear the most stubborn clogs, however, these resisted even that, I've tried drawing the ink out with hot water, soaking and flushing the heads with denatured alcohol solvent, filling empty tanks with alcohol solvent and allowing them to sit in the head for several days, nothing seems to work. the banding pattern is not always the same, as you would see if it was specific nozzles not operating, or a logic board or wire fault.
is there any solution aside from replacing the very expensive print head that will take care of this problem????

6 replies

by zlitocook

You did not say you looked at this. did you check the roller and feeder? If some thing pressed the roller or feeder it could have left a indent in it. It might not be seen by vary easyly.

by ogum666

problem is in the ink head, streaks are consistant across the entire width and do not repeat in intervals as you would see with a roller defect....

This discussion is closed to new replies.