Discussion Locked

Error 164

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Compaq computer that had a 64mb memory chip (standard) and I installed a 128mb chip (centon pc133)when I booted it gave me error message: 164-memory size error...It rebooted it self and it recognized 188mb installed and in the system properties window it says 184mb...Now I get Explorer error messages like invalid page fault in module (unknown)...Can anyone help?

7 replies

by richard_barsby

Hi this is probaly due to differing memory types. try the machine with only the 128mb installed and see if the fault disappears.

Best of luck

Rich

by dmiles

Compaq reports it as Memory Configuration Incorrect
Run Computer Setup
At Startup hit key to open the CMOS Control panel
If you have athe owners manual,it would be helpful to you when you locate the memory section in the panel to set the configuration on lthe type and size of memory

by vivisector

Try taking the memory DIMMS out and blow the gold plated connector ends off, reseeding them will usually resolve this problem. What works even better is to use an eraser end and rub the connectors to clean any residue buildup. Make sure when you do this that you are properly grounded to the machine, to insure you don't blow the memory due to static. If this fails, try booting with only 1 DIMM installed to see which one is causing the problems. You may need to replace one of your DIMMS as this problem can happen when the memory is installed without static protection, and has some of the banks blown.

This discussion is closed to new replies.