Discussion Locked

EtherNIC switch settings

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello all,

I have an old network card which I am looking for DIP switch settings for so that I can set the IRQ and IO port address.

The card is labelled with "ETHERNIC-16 REV.C" and the main chip is a Winbond W89C90.

There is a jumper block in the top right hand corner labelled "JUMPER" and there is a block of 8 DIP switches located at SW1.

I am looking for diagrams or instructions on how to set these, as I do not know at present which port this card sits at.

Any help would be appreciated!

2 replies

by junker

This does not appear to be the card that I am looking for.

The card described in this PDF has a jumper block of nine jumpers, and the card that I have has a DIP switch block of 8 switches.

Also, the transcievers on the card described in thatPDF are different - my card only has an AUI port and a 10base2 (BNC) port.

The chips are also different - the only chips are a Winbond W89C90 and two Hyndai 16k RAM chips. There are also quite a few 74LS's, but the first "large square chip" mentioned in the manual is not there.

Thanks anyway

This discussion is closed to new replies.