Discussion Locked

Ever tried to refurbish a cpu fan?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We go through a tremendous number of cpu fans. I know it is a small investment for such a huge risk, but there are times I feel we aren't handling it right.

When I have a case open, and it is dusty, I blow it out. Especially the fan and heat sink. But I have noticed that often after being blowed out, the fan starts making noise and soon goes out. I figure I am blowing some of the dust up into the bearings of the fan and shortening it's life. But the heat sink can't be covered in dirt either.

My question is: Has anyone ever tried a white lithium spray or WD40 spray lightly in the bearings? That should not create a fire hazard, but I am too nervous to try it. Has anyone else heard of such a thing or tried it themselves?

Ijust hate to keep tossing $15 fans that I just put in last month because they rattle.

Suggestions welcome!

Thank you in advance for the help.

Michelinda

3 replies

by tbradley

The "canned air" is a PC tech's worst
nightmare, especially if it gets into
the wrong hands :)

You're correct in that "blowing" dust can
create more problems than removing it. It'll
get deeper into fan bearings, disk drives, power supplies,and other small cracks and
crevices.

Obtain a fairly strong vacumn with a small plastic or non-metallic nozzle, and a small brush attachment. Use the brush to get the
big pieces, then use the nozzle to selectively clean areas that need them.

I wouldn't recommend using WD40 near the
computer at all. Not because it's a fire
hazard, but because it's petroleum based, and
can damage the etchings, and the system board itself. Same with the Lithium spray. The
bearings of the CPU fans are just little
plastic sleeves, with some fairly loose
tolerences. If vacumning reduces the noise, leave it alone, but if it persists, then
remove the fan, and put a small drop of
3 in 1 oil in the bearing.

by michelinda

Excellent suggestions and I really appreciate it. I doubt I can get the company to get me the vacuum, but I might invest myself. When I did this regular at home, I had a Rainbow vacuum (household vac) that I kept under my work counter with air freshner in the water. It had a special small nozzle attachment and I used it, not air. But here...well, you know. Thank you tremendously for the hints and I will put them to use! I am sure you have saved us money.

This discussion is closed to new replies.