Discussion Locked

Excessive Line Voltage

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I receive an error message "excessive line voltage disconnect phone line from modem or damage may occur" when the line isn't even plugged in(checking to see if it detects a dialtone. It responds in the control panel). Other units on the same line don't have that problem. I've never seen this problem before. It's an Emachine 333k with an Eiger Labs modem(chipset PCT789T-A). I've tried 8 different drivers with no luck. The problem occured after a fresh standalone reload of WIN98 1st edition. Any thoughts or ideas would be appreciated.

2 replies

by xandero

Hmmm...I have never seen this either, but if this was a machine that I really cared about, I would back-up my files and do a good ol' fashioned reformat of the Hard Drive. Then reinstall the OS. If this does not work, you should be reassured that it is indeed a hardware problem. -XanderO

by xandero

Hmmm...I have never seen this either, but if this was a machine that I really cared about, I would back-up my files and do a good ol' fashioned reformat of the Hard Drive. Then reinstall the OS. If this does not work, you should be reassured that it is indeed a hardware problem. -XanderO

This discussion is closed to new replies.