Discussion Locked

Ext. ZIP Drive not detected in NT

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Have updated BIOS, software, and drivers. Tried all available modes for parallel port in BIOS as well. At a loss now. Any help would be much appreciated.

6 replies

by ann777

Zip drives do fail. Do you have another system with a working zip drive? Try swapping the drive with another working drive.

Just yesterday, I swapped a working zip drive with another that we were trying to get working, and the unit would not be recognized. Put the original unit back on, and had no problem.

by stillatit

1. You need the proper Zip drivers loaded.
2. Your printer needs to be set to ECP
3. Check your cable. Make sure you are using only the Zip cable provided, and that you have not swapped the ends (The end marked Zip goes into the Zip drive.). Do NOT daisy-chain through other devices such as a scanner.
4. In the device manager, the device will appear as a SCSI driver.

Good luck.

This discussion is closed to new replies.