4 replies
by tod.m.clites Accepted solution
by w2ktechman Accepted solution
different HDD's will have different jumper settings for master/slave/cable select.
the incorrect setting may destroy the drive so be careful.
Also, the cable will have either master by one connector (or drive 0), slave by another (or drive 1), and CPU by another. Plug these in to the drives properly as well. If you are unsure about settings, use cable select and then plug the cables in to assign master/slave settings.
or GO TO SCHOOL -- wait, I wasnt supposed to add that part -- lol.
how bout READ A BOOK. -- I think thats better, dont you?
hope this helps, but if there are still problems, have the BIOS check the hdd's to see if there are problems. these tests can be anywhere from 10 min-2 hours and more.
by ozi eagle Accepted solution
Hi Tod,
In my experience, external HDDs must be set as master on the jumpers, other settings just don't work
by w2ktechman Accepted solution
I mostly use notebook drives as external drives. Usually they are set to cable select and work fine in the multibay that I use.
maybe it depends on the multibay or drive tray?
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending