Question Locked

External Hard Drive recognized/ unrecognized with Vista

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Ok, so I have an external harddrive I used with my old PC that used XP. I now have a new laptop running VISTA. Once plugged in it is recognized, works for a few minutes ( I am able to access all files) then suddenly an error pops up saying the device is not recognized.

I have tried deleting the file posted in another forum (INFCACHE1) and the only thing this did was come up with the error quicker when I plugged it back in.

Not a power supply problem as it has its own power supply other than the USB connection. Ive also tried to use it on another XP system and it is not recognized at all.

Any help would be greatly appreciated!
Thanks
Lisa

3 replies

by robo_dev

but I wish there were a single common solution.

Two ideas:

1) If the external drive is a branded-device (e.g. LaCie or Seagate), then look for vista drivers for that device.

2) Power management settings: If Windows is configured to power down the drive or USB port after five minutes to save power, that could be the problem.

see link below for someone with a similar problem:
http://www.tomshardware.com/forum/249281-32-seagate-external-vista

It may be hard to tell, but is the drive spinning-down right before it becomes unavailable?? If the drive is spinning-down, then I would say it's power-mgmt related for sure.

by oh smeg

It could also be a Vista Incompatible Chip Set that has suffered some damage when connected to Vista.

But the very first thing you need to do here is test the unit with the Makers Testing Utility for correct function. so look here for your Drive Makers Name and get their testing Utility

http://www.tacktech.com/display.cfm?ttid=287

Ideally you should test this on a XP System if you have one. As for XP as well have you looked in the Drive Management to see if the drive is appearing there. Vista may have made some changes which XP doesn't like.

Lastly while I don't think that this is the problem you should bare it in mind. Vista uses a Different Partition Tool to XP original and can not read Partitions made under XP Original owing to a change in Security Settings. If you formatted the HDD with XP SP2 or newer Vista will not have any problems reading it but if it was originally formatted with something older Vista is very unlikely to be Abie to read that drive. Please Note I said Format not use with. ;)

Col

This discussion is closed to new replies.