Discussion Locked

External Hard Drive & Win XP

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Valuestor Mobile Hard Disk Transformer that turns a standard IDE Hard Drive into an external hard drive that connects to the computer via a parallel port ( like a printer or scanner would).

I worked fine with Windows 95, and Win 98 SE.
I have now upgraded to Windows XP and even though I have installed the drivers from the disk, the computer doesn't seem to recognize that the drive is connected.

I can't seem to find updated drivers for this damn thing anywhere on the web, nor find the orginal manufacturer or a vendor.

SPECS:
PPort IDE HD Transformer
PN 10457-XX
Ser No. 583-009599
Manuf. by Valuestor, Inc. San Jose CA

I really need to make this thing work, I have no room in the computer case to install it directly and I use this 4 GB drive to transfer data between my Laptop and my desktop.

10 replies

by bmille14

At the current time it doesn't look as if this particular product is supported by Windows XP. Because Windows XP is based on NT/2000 technology and requires different drivers than were used under Windows 9x, you need to use the HCL (Hardware Compatability List) http://www.microsoft.com/hcl/
to see if a hardware device is natively supported.
OR
Get the appropriate device driver from the manufacturer. I've checked WinDrive.com and DriverGuide.com and a Windows XP device driver is not currently available. You may want to check these sites, as well as Windows Update, in the future to see if a driver will be made available.

by tjc

I have quite a few legacy hardware products that I use, video capture, sound, external hard drives, etc that don't have drivers for xp yet. so what I did was have a 98 comtpuer connectected to my network and just use it off of that one. you may have to do the same. else you may want to get one of them new usb thumb drives, if you can affored a big one i use a 64 mb one from sony called a microvault.

by boli

put the legacy drivers on and run it thru compatability mode, that should work.

by kmcniff

In Device Manager, check the properties of the Parallel Port. Check the Port Settings tab and check the box that says "Enable Legacy Plug and Play Detection".
Many devices that worked on the Parallel port in 9.x use a "Probe" of the port to be detected. I have had to use this for just about all Parallel port devices that worked under 9.x and did not work with W2k/Xp. The old drivers should work, or the system will install a driver.

by queryeverything

Assuming you've updated both your Desktop and Notebook to WinXP and they both have USB, if you want to still use your same HDD, you can get an IDE HDD enclosure with USB interface for about $120. A cheaper solution is an IDE/USB Adapter for about $30. The Adapter solution doesn't look pretty but it works.

by harold.fullerton

Although not with this exact device, I have succeeded with the compatibility mode change in the bios. The movement over the network is fastest but when not convient, I use a USB connection with an external case. NewEgg has a BYTECC for less than $40. that works great.

by techwriter

I had a similar problem trying to use a 160 GB IDE hard drive in a case, connected through USB 2.0, and found the solution to getting XP SP2 to recognize the hard drive was to convert the disk format to FAT32. For some reason, it refused to acknowledge an NTFS formatted disk via USB. It works like a champ now.

by grover99

I have the Ultra drive enclosure suggested above from TigerDirect, and it's great. However, are you using this enclosure on the same PC as before? Did you upgrade the BIOS when upgrading the OS? Might consider checking the BIOS and verifying that you have your parallel port set to ECP/EPP/PS2 mode rather than standard mode!

by tom.lewis

I recently had the same problem with a laptop and and external drive that worked throught the PCMCIA card interface. The hard drive worked with a Toshiba laptop but not an IBM. It turned out the problem was with the drive jumpers.

This discussion is closed to new replies.